A living field manualObserve · Make · Mend

Water / Distribution

Gravity-Fed Water.

Understand why elevation gives water pressure and why narrow pipes reduce usable flow.

DifficultyBeginnerAllow30 minutesTypeUseful · Building
Tank surface above an outlet, vertical head arrow and a separate sloping delivery pipe.
PLATE 021 Concept study · read the steps and limits below.

Why it matters

At rest, water pressure depends on vertical height between the water surface and the outlet. Each metre of water head gives about 9.8 kPa, or 1.42 psi. Pipe length does not add static pressure; friction reduces available pressure while water flows.

What you’ll need

Tools

  • Tape measure
  • Notebook

Materials

  • Water system sketch

Before you begin

Safety & limits

  • Water quality is independent of pressure. Loaded tanks and permanent plumbing require appropriate design.

Work carefully, in order

The method

  1. 01

    Draw the levels

    Sketch the water surface in the tank and the proposed outlet. Measure their vertical difference, not the length of the sloping pipe. Label the highest and lowest likely tank levels; pressure changes as the tank empties.

  2. 02

    Estimate static head

    Multiply vertical metres by about 9.8 to estimate kilopascals. For a surface three metres above a tap, static head is roughly 29 kPa. Treat this as a theoretical starting point, not a promise of flow at a sprinkler.

  3. 03

    Trace restrictions

    Mark pipe diameter, length, bends, filters, valves, and uphill sections. Flowing water loses energy to friction. Small bore and dirty filters can leave little usable pressure even when the tap is visibly downhill.

  4. 04

    Match the equipment

    Check minimum operating pressure for emitters, taps, or appliances. Choose products intended for low head if necessary. Have a qualified designer assess tank supports, pipe ratings, overflow, and backflow protection before building a permanent system.

  5. 05

    Test without cross-connection

    For a low-risk outdoor non-potable installation, record actual flow at different tank levels and check for leaks. Label outlets. Do not connect to potable plumbing or use an elevated improvised tank stand as an experiment.

Mistakes to avoid

  • Using pipe length as head
  • Ignoring pressure loss through filters
  • Assuming a taller stand is automatically safe

If it isn’t working

Good initial stream fades

Check tank venting, falling level, and blockage.

Emitter barely flows

Compare its pressure requirement with available head.

Then & now

Historical context

Elevated reservoirs and hillside channels use the same physical principle as a modern water tower.

The modern equivalent

A properly selected pump can provide pressure where elevation is insufficient.

Sources & review

Editorial draft — specialist review pending. Written 2026-09-20. Sources support the stated scope; this page has not been professionally certified.

This entry describes general practice. A topic-specific source review is still required before it can be marked reviewed.

How this manual handles evidence →

Keep the connection

Related skills.

Back to Water ↗